Hillman Stainless Steel Pan Head Phillips Sheet Metal Screws, #6 to #12, 1/2" to 2" Lengths
Hillman Stainless Steel Pan Head Phillips Sheet Metal Screws, #6 to #12, 1/2" to 2" Lengths
Hillman stainless steel pan head Phillips sheet metal screws are self-tapping fasteners built for joining light-gauge metal, wood, and fiberglass on boats, trailers, and marine hardware installations. The fully threaded, sharp-point shaft bites into thin material without a pilot hole in most applications, while the 18-8 stainless steel construction resists rust, salt spray, and corrosion far better than plated steel. The low-profile pan head with Phillips drive seats flush for a clean finish on hatches, vents, cleats, trim, and electrical boxes. This line spans #6 to #12 thread sizes and 1/2 inch to 2 inch lengths, sold in small multi-packs sized to the job.
Specifications
- Brand: Hillman
- Fastener Type: Sheet Metal Screw (Tapping Screw)
- Material: Stainless Steel (18-8)
- Head Style: Pan
- Drive System: Phillips
- Thread Coverage: Fully Threaded
- Thread Type: UNC
- Thread Style: Right Hand
- Point Style: Sharp
Sizes & Options
Match the thread number to the hole or clearance you are fastening into and the length to your combined material thickness, allowing the point to fully penetrate the base material without bottoming out. Available from #6 x 1/2 inch up through #12 x 1-1/2 inch, each in a resealable multi-pack sized from 2 to 5 pieces depending on screw size. If you are unsure which size fits your repair, match the diameter and length of the screw you are replacing.