T-H Marine HC Series Stainless Steel Hose Clamps - Available in 7/16" to 1-1/2" Clamping Range
T-H Marine HC Series Stainless Steel Hose Clamps - Available in 7/16" to 1-1/2" Clamping Range
T-H Marine's HC Series hose clamps are built for boats, where a slipped fuel line or a leaking bilge hose is not a minor inconvenience. Every part of these clamps, not just the band, is made from 300 series stainless steel, so the housing, band, and tightening screw all resist saltwater corrosion at the same rate. The worm gear design lets you dial in even, consistent pressure around the hose with a simple flathead screwdriver or nut driver, and the smooth rolled band edge protects hose material from cutting or wear over repeated tightening cycles. Whether you are securing a fuel line, raw water intake hose, or bilge pump discharge, these clamps hold up to 1000 PSI of clamping force to keep connections sealed under vibration and pressure.
Specifications
- Brand: T-H Marine
- Material: 300 Series Stainless Steel (band, housing, and screw)
- Style: Classic worm gear
- Color: Silver
- Tensile Strength: 1000 Pounds Per Square Inch
- Clamping Range: 7/16 inch to 1-1/2 inch (size-dependent)
Sizes & Options
This line covers two clamp sizes based on the diameter of hose you need to secure. The HC-10 fits smaller hoses from 7/16 inch to 1-1/16 inch, ideal for fuel lines and small plumbing runs. The HC-16 steps up to a 11/16 inch to 1-1/2 inch range, suited to larger raw water, bilge, and washdown hoses. Measure the outside diameter of your hose at the point where the clamp will sit, then choose the size whose range comfortably includes that measurement with room to tighten down.