Tie Down Engineering Split Panel Keel Roller Bracket Set - Fits 1/2" or 5/8" Shaft

Keep your boat's keel roller mounted securely and adjusted to the right height with this Tie Down Engineering split panel bracket set. Sold as a matched pair of left and right side brackets, this set bolts directly to your trailer's keel guide and holds a keel roller shaft of either 1/2 inch or 5/8 inch diameter, so it covers the two most common roller shaft sizes found on boat trailers. Each bracket is stamped from one-piece, heavy-duty 11 gauge steel and hot dip galvanized after fabrication for strong resistance to rust, salt spray, and everyday trailering abuse. Slotted mounting holes let you raise or lower the roller to match your boat's hull profile, making it easy to fine-tune keel support during loading and launching. Whether you are replacing a bent or corroded factory bracket or upgrading a DIY keel roller setup, this split panel bracket set restores solid, adjustable support at an affordable price.

Specifications

• Brand: Tie Down Engineering
• Material: Hot dip galvanized steel, 11 gauge
• Fits roller shaft diameter: 1/2 inch or 5/8 inch
• Mounting bolt slot size: Accepts 7/16 inch or 1/2 inch diameter bolts
• Adjustment: Slotted holes for vertical roller height adjustment
• Sold as: Set of left and right side brackets
• Finish/Color: Galvanized silver
• Vehicle service type: Boat trailer

Sizes & Options

Both part numbers in this line, 86153 and 81235, fit the same 1/2 inch or 5/8 inch keel roller shaft diameters and share the same galvanized 11 gauge steel construction. Choose based on your preferred part number or price point; either set gives you a full left and right bracket pair for a single keel roller mount.