Turning Point Propellers Hustler Hub Kit 11100101, Interchangeable Propeller Hub System

The Turning Point Propellers Hustler Hub Kit 11100101 is an interchangeable hub system built to protect your outboard's gear case and drivetrain from the impact of shifting and sudden load changes. It installs inside a compatible Turning Point propeller to absorb gear shock, cutting down on the vibration and chatter that can develop as a propeller wears or takes repeated hard shifts. The kit is designed for use with Evinrude outboard propellers, giving boaters a replacement hub option that restores a secure, tight fit between the propeller and the drive shaft.

Inside the hub, corrosion resistant brass splines pair with a nylon body to transfer engine power smoothly while resisting the saltwater and freshwater exposure that marine hardware faces season after season. This construction is what allows the kit to eliminate spun hubs, a common failure point where a worn hub lets the propeller spin independently of the shaft, and to stop the cracking that can develop in aging or damaged hubs over time. Replacing a worn hub with this kit restores proper power transfer without requiring a full propeller replacement.

The hub kit measures 4.8 x 2.2 x 2.2 inches and weighs 1 pound, with a machined exterior finish for consistent fit and balance. It is sold as a direct-fit replacement hub for boaters running compatible Turning Point propellers who need to service or upgrade the hub rather than the entire propeller.

Specifications

• Brand: Turning Point Propellers
• Manufacturer Part Number: 11100101
• Application: Evinrude Outboard Propellers
• Product Dimensions: 4.8 x 2.2 x 2.2 inches
• Weight: 1 pound
• Exterior Finish: Machined
• Material: Brass and nylon
• UPC: 652480200588

Frequently Asked Questions

What is the Turning Point Propellers Hustler Hub Kit 11100101 used for? Hub kit 11100101 is an interchangeable hub system installed inside a compatible Turning Point propeller to absorb gear shock and protect the engine and drive from impact damage during shifting.

Will this hub kit fit my propeller? The Turning Point Hustler Hub Kit 11100101 is designed for use with Evinrude outboard propellers; check that your propeller uses a Turning Point interchangeable hub system before ordering.

What are the dimensions and weight of hub kit 11100101? Hub kit 11100101 measures 4.8 x 2.2 x 2.2 inches and weighs 1 pound.

What is the hub made of? The 11100101 hub is built with corrosion resistant brass splines and a nylon body, a combination chosen to hold up against saltwater and freshwater exposure.

Does this kit prevent spun hubs? Yes, the design of the 11100101 hub kit is intended to eliminate spun hubs, where a worn hub allows the propeller to spin independently of the drive shaft.

Can this hub kit fix a cracked hub? Installing the Turning Point Hustler Hub Kit 11100101 replaces a cracked or worn hub, restoring proper power transfer and ending the cracking issue at its source.

Do I need to replace the whole propeller if the hub wears out? No, hub kit 11100101 lets you replace just the hub inside a compatible Turning Point propeller instead of replacing the entire propeller.

What finish does the hub have? The 11100101 hub kit has a machined exterior finish.

Does this hub kit reduce propeller vibration? Yes, installing the Hustler Hub Kit 11100101 is intended to minimize propeller vibration and chatter caused by a worn or loose hub.

Is this a genuine Turning Point Propellers part? Yes, hub kit 11100101 is manufactured by Turning Point Propellers as part of its interchangeable hub system for its propellers.