Gen3 Marine 4 Bow Pontoon Bimini Top, Gray - Available in 54" H x 8' L (91-96" Beam) and 56" H x 8' L (97-103" Beam)

The Gen3 Marine 4 Bow Pontoon Bimini Top gives your pontoon boat shade you can count on, without the sag and fade that cheaper canopies pick up after a season on the water. The 4 bow aluminum frame spreads the fabric evenly across the full length of the top, so you get consistent coverage from bow to stern instead of the dips and low spots common on 3 bow designs. The canopy itself is cut from 600D solution-dyed marine fabric, a material that resists UV fading, sheds water, and stands up to mildew growth far better than standard printed or laminated fabrics. The frame is built from round aluminum tubing with nylon fittings at every joint, so it will not rust or seize up even after repeated folding, wet storage, and sun exposure. Everything needed to mount the top is in the box: the fabric canopy, the aluminum fittings, and the rear support poles that keep the frame stable while underway. This top is rated to stay open at speeds up to 20 mph, so you are not stuck dropping the canopy every time you get the boat moving, though it should still be folded down and stowed for trailering.

Specifications

• Brand: Gen3 Marine
• Design: 4 bow pontoon bimini top
• Fabric: 600D solution-dyed, UV and mildew resistant
• Frame: Aluminum round tube with nylon fittings
• Color: Gray
• Included: Bimini fabric, aluminum fittings, rear support poles
• Max underway speed (open): 20 mph
• Available frame heights: 54 inches or 56 inches
• Available frame lengths: 8 feet (folded out)
• Available beam fitment: 91-96 inches or 97-103 inches

Sizes & Options

This bimini top is sold in two frame sizes matched to different pontoon beam widths. Measure your boat's beam (the width across the pontoons) before ordering: choose the 54 inch H x 8 foot L version if your beam falls between 91 and 96 inches, or the 56 inch H x 8 foot L version if your beam falls between 97 and 103 inches. Ordering the correct beam fitment is the most important step, since a top sized for a narrower or wider beam will not stretch or seal properly across your frame.