T-H Marine ELL-118 90 Degree Barbed Elbow Hose Fitting, 1-1/8 Inch ID Hose

The T-H Marine ELL-118 is a 90 degree barbed elbow fitting molded specifically to fit marine hose dimensions. It lets you make a clean 90 degree turn in hose routing without kinking the hose, so runs stay open and flow is not restricted at tight bends. The fitting can also be used as a hose junction when repairing a damaged section of hose, joining two lengths back into a continuous run.

Both legs of the ELL-118 share the same barb dimension, sized to fit 1-1/8 inch ID hose. The barbed profile grips the inside of the hose to help the connection resist slipping and pulling loose under vibration and water pressure, and is intended to be secured with a hose clamp on each leg for a complete installation.

This fitting is part of a broader T-H Marine barbed elbow lineup covering multiple hose sizes, so it is built to the same design and fit standard used across that family. It is a straightforward, functional fitting for boat builders, hose repair, and general plumbing runs anywhere a 90 degree hose turn is needed.

Specifications

• Brand: T-H Marine
• Manufacturer Part Number: ELL-118
• Product Type: 90 Degree Barbed Elbow Hose Fitting
• Hose Fitting Size: 1-1/8 inch ID hose
• Angle: 90 degrees
• Barb Configuration: Same barb dimension on both legs
• Weight: 0.11 pounds
• UPC: 733572064322

Frequently Asked Questions

What hose size does the T-H Marine ELL-118 fit? The ELL-118 is sized for 1-1/8 inch ID hose on both legs of the elbow, since both legs share the same barb dimension.

What angle is this elbow fitting? It is a 90 degree elbow, allowing a hose run to turn a full right angle without the hose itself kinking.

Can the ELL-118 be used to repair a damaged hose? Yes, the ELL-118 can be used as a hose junction to splice two hose sections together when repairing a damaged run, in addition to its normal use for routing turns.

Why use a barbed elbow instead of just bending the hose? Bending 1-1/8 inch ID hose sharply can kink it and restrict flow; the ELL-118's molded 90 degree barb lets the hose route around a corner while staying fully open.

How much does the ELL-118 weigh? The T-H Marine ELL-118 weighs 0.11 pounds.

Does the ELL-118 need hose clamps to install? The barbed legs are designed to grip the inside of 1-1/8 inch hose, and each leg should be secured with a hose clamp for a complete, leak-resistant connection.

Are both legs of the ELL-118 the same size? Yes, the ELL-118 has the same barb dimension on each leg, both sized for 1-1/8 inch ID hose.

Is the ELL-118 part of a larger size range? T-H Marine makes this same barbed elbow design in multiple hose sizes, with the ELL-118 covering 1-1/8 inch ID hose specifically.

What is the UPC for the T-H Marine ELL-118? The UPC for the ELL-118 90 degree barbed elbow fitting is 733572064322.

Is the ELL-118 made for marine hose dimensions specifically? Yes, the ELL-118 is molded specifically to fit marine hose dimensions rather than generic industrial hose sizing.